Introduction to 3D Printing at the Library - Learn To Be a Maker
Introduction to 3D Printing at the Library - Learn To Be a Maker takes place on Thu, Sep 24, 2026 at 3:00 PM (CDT) at Martin Regional Library in Tulsa, OK, and runs until 4:00 PM. Entry is free; the listing is on Luma.
About this event
Tulsa City-County Library teaches the basics of 3D printing to tweens and adults. Visitors learn how the service works in this educational session.
Full description from organizerShow less
Learn the basics of 3D printing and how this service works through Tulsa City-County Library. For tweens to adults.
Keep going
All Tulsa events →189
events in September
Browse September →
22
conferences & summits this week
Conferences & Summits →
1
on today near you
Near me →
178
free in Tulsa
Free events →
Similar events
View all →
Free Coworking at The Root - East Village
Thu, Sep 24 · Free
Free Coworking at The Root - Market Station
Thu, Sep 24 · Free
Gradient Free Coworking
Thu, Sep 24 · Free
The Williams AI Adoption Journey
Thu, Sep 24 · Free
Starframe Capital Meet and Greet: Dockware
Thu, Sep 24 · Free
Tulsa Tech Week: OKWIT x WIT+
Thu, Sep 24 · Free
Amplify Tulsa Nonprofits
Thu, Sep 24 · Free
Gradient Free Coworking
Fri, Sep 25 · Free
Details
- When
- Thu, Sep 24, 2026 · 3:00 PM (CDT) · until 4:00 PM
- Where
- Martin Regional Library
- Address
- Martin Regional Library, 2601 S Garnett Rd, Tulsa, OK 74129, USA
- Price
- Free
- Genre
- tech
- Weather
- 87°F · OvercastForecast at 3:00 PM (CDT)
Questions
- When is Introduction to 3D Printing at the Library - Learn To Be a Maker?
- Thu, Sep 24, 2026 at 3:00 PM CDT.
- How much are tickets for Introduction to 3D Printing at the Library - Learn To Be a Maker?
- Entry is free.
- Where is Introduction to 3D Printing at the Library - Learn To Be a Maker?
- Martin Regional Library, Martin Regional Library, 2601 S Garnett Rd, Tulsa, OK 74129, USA, Tulsa, OK.
- Where can I buy tickets for Introduction to 3D Printing at the Library - Learn To Be a Maker?
- Tickets are sold on Luma. This page links straight to that listing; no tickets are sold here.
- What time does Introduction to 3D Printing at the Library - Learn To Be a Maker end?
- It runs until 4:00 PM.